Can you please let me know if RuneAudio v0.4-beta supports the IQaudio Pi-Digi+ card?
I've installed this on my RPI3 but cannot get the card to work or show up under the MPD screen in the webinterface. Any ideas?
What I've tried so far (based on the IQ user guide p.29 ):
1. I've disabled the standard sound modules by editing /etc/modules-load.d/raspberrypi.conf and commenting out the following line:
#snd_bcm2835
2. I've attempted to enable the iqaudio digi card by editing /boot/config.txt and adding the following lines:
#dtparam=audio=on
dtparam=i2s=on
dtoverlay=iqaudio-digi-wm8804-audio
- MY SETUP -
RPI3
Rune Audio v0.4 beta
IQaudio Pi-Digi+
- EXTRACT FROM MY /BOOT/CONFIG.TXT -
(this is not the full config as it would have been massive. Happy to share the full config file if needed.)
#dtparam=i2c_arm=on
#dtparam=i2c_vc=on
#dtparam=spi=on
#dtparam=act_led_trigger=mmc
#dtparam=audio=on
dtparam=i2s=on
#dtparam=uart1=off
#dtoverlay=pi3-disable-bt-overlay
# Uncomment one of these lines to enable an audio interface
#dtoverlay=hifiberry-dac
#dtoverlay=hifiberry-dacplus
#dtoverlay=hifiberry-digi
#dtoverlay=hifiberry-amp
#dtoverlay=iqaudio-dac
#dtoverlay=iqaudio-dacplus
dtoverlay=iqaudio-digi-wm8804-audio
Thanks
Levin
